Removing the hopper service panel — also called the access, bottom, or side panel — is one of the most common steps required for any troubleshooting. This article explains how to remove and replace the hopper service panel on a D2 grill.
Applies to: D2 Grills (Century 885 · Ironwood 650 · Ironwood 885 · Pro 575 · Pro 780 · Redland · Redland XL · Ridgeline XL · Silverton 620 · Silverton 810 · Silverton XL · Timberline 850 · Timberline 1300)
| SKU | Grill |
|---|---|
| KIT0394 |
Century 885 · Ironwood 650 · Ironwood 885 · Redland · Redland XL · Silverton 810 |
| KIT0414 |
Pro 575 · Pro 780 · Ridgeline XL |
| KIT0483 |
Timberline 850 · Timberline 1300 |
| KIT0531 |
Silverton 620 · Silverton XL |
Replacement Instructions
| Tools Needed | Phillips Screwdriver |
|---|---|
| Estimated Time to Complete | 5 Minutes |
Removing the hopper service panel varies by grill model. Some panels cover only the bottom, while others extend up the hopper’s side in an L-shape. Expand the section for your grill’s SKU to remove or replace the panel.
Bottom Panel (KIT0414)
To Remove the Panel:
- Power off and unplug your grill.
-
Unscrew the x2 Phillips screws on the right side of the hopper and remove the access panel from the bottom of the hopper.
The opposite side of the access panel has two lips that hook through the hopper cavity. You will need to slide the panel towards the grill slightly for the panel to come loose.
- Panel is removed, you now have access to the internal components.
To Reinstall the Panel:
- Align the two lips nearest the grill side with the hopper cavity slots.
- Align the other side inside the hopper cavity until the screw holes line up.
- Insert the x2 Phillips screws.
- Panel is reinstalled.
L-Shaped / Side Panel (KIT0394 · KIT0483 · KIT0531)
To Remove the Panel:
- Power off and unplug your grill.
- Remove the service panel from the bottom of the hopper by removing the x4 Phillips screws.
- Panel slides down off of the hopper cavity.
- Panel is removed, you now have access to the internal components.
To Reinstall the Panel:
- Slide the panel back into place and align the screw holes.
- Insert the x4 Phillips screws.
- Panel is reinstalled.
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.