How to Replace the Power Panel & Power Cord on a Flatrock 3-Zone Griddle

Applies to: Flatrock 3-Zone 

Part #:	Description:
FTK0013	Power Panel
FTK0044	Power Cord - Model: TF3CN59AU
FTK0094	Power Cord - Model: TF3CN59AN

Related Articles

• Power Cords

Tools Needed

• Phillips Screwdriver

Estimated Time to Complete

• 15 minutes

Replacement Steps

Remove Old Power Panel

1. Find the power panel on the back of the grill, unplug the power cord, and remove the 9V battery, if one is installed.
   
2. Remove the 4 screws (2 on the left and 2 on the on right) securing the power panel to the grill.
3. Pull Panel away from the grill and make note of the placement of the electrical wires. 
   • 6 Wires: 2 connected to the power switch, 2 connected to the battery compartment and 2 connected to the power outlet
     
     
4. Disconnect all wires.

Install New Power Panel

1. Attach the 6 wires to the new power panel.
2. Secure the power panel back to the grill using the 4 provided screws or using the screws you removed in step 3.
   

Replace Power Cord

1. Locate the Power cord on the back side of the grill.
   • The power cord plugs into the power panel
2. Remove the power cord.
3. Replace and attach the new power cord.

Using an Extension Cord

If you need to use an extension cord with your Flatrock, we recommend the following:

• Confirm a GFCI outlet is used
• Use an outdoor rated extension cord
• Minimum wire gauge of 14 AWG