Step-by-step instructions for how to replace the the bracket on the side shelves on your Traeger Flatrock grill. Includes part numbers, required tools and estimated completion time.
Applies to: Flatrock 2-Zone | Flatrock 3-Zone
Part 2-Zone & 3-Zone SKU TF3CN59AN
3-Zone Grill SKU TF3CN59AU
Front - Right, Back - Left FTK0076
Front - Left, Back - Right FTK0078
Front - Right, Back - Left
FTK0030 (Buy on Traeger.com)
Front - Left, Back - Right
FTK0042 (Buy on Traeger.com)
Flatrock 2-Zone
Tools Needed
- Phillips Screwdriver
Estimated Time to Complete
- 10 minutes
Before Performing Any Replacement Steps:
- Move all control knobs to the OFF position
- Unplug the grill from power, close the propane tank and disconnect the regulator hose
- Remove the P.A.L. rails from the grill.
- Remove Side P.A.L. rails before the front P.A.L. rails.
- Loosen all the bolts holding the P.A.L. rail in place. Once loosened, the P.A.L. rail should be able to be lifted off the bolts and away from the shelf.
- Fold down the shelf.
- Remove the 2 screws attaching the shelf to the bracket, 1 on front and 1 on back.
- Repeat on both sides.
- With those 2 screws removed the shelf should be able to be separated from the grill, leaving the bracket attached.
- Replace the brackets
- Remove the 2 screws from the front bracket, and the 2 from the back bracket.
- Install the new bracket.
- Reinstall the shelf by attaching to the new brackets with the 4 screws previously removed.
- Reinstall the P.A.L rails on reinstalled shelf.
- Repeat on the other side if replacing all brackets.
Flatrock 3-Zone
Tools Needed
- Phillips Screwdriver
Estimated Time to Complete
- 10 Minutes
Before Performing Any Replacement Steps:
- Move all control knobs to the OFF position
- Unplug the grill from power, close the propane tank and disconnect the regulator hose
- Fold down the shelf.
- Remove the 4 screws attaching the shelf to the bracket, 2 on front and 2 on back.
- With those 4 screws removed the shelf should be able to be separated from the grill, leaving the bracket attached.
- Replace the brackets:
- Remove the 2 screws from the front bracket, and the 2 from the back bracket.
- Install the new brackets.
- With the new brackets installed, install the shelf following the steps outlined in the assembly guide.
- Partially screw in 8 screws (G) into each of the two side shelves. Do not tighten all the way.
- Insert the two side shelves into the new brackets, adding an additional screw once in place.
- Reinstall the four P.A.L Rails in the following order: Front-left > Side-left > Side-right > Front-right.
Still need help?
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.