Step-by-step instructions for how to replace the heat shield on your Traeger Flatrock 2-Zone grill. Includes part numbers, required tools, and estimated completion time.
Applies to: Flatrock 2-Zone (TF2NN46DN USA | TF2NN46DNC CA)
Part #: Model: FTK0127 Flatrock 2-Zone
Where do I find the heat shield? The heat shield is located underneath the griddle next to the grease keg.
Tools Needed
- Phillips Screwdriver
Estimated Time to Complete
- 5 minutes
Replacement Steps
Before Performing Any Replacement Steps:
- Turn burner knobs to OFF position, close the propane tank, and disconnect the regulator.
- Using a Phillips screwdriver, remove the x3 screws holding the heat shield in place (2 screws on the grease keg rail side, 1 screw on the opposite side).
- Remove the old heat shield and replace with the new heat shield.
- Replace the x3 screws.
Still need help?
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.