Step-by-step instructions on how to replace the side shelf, and the side shelf P.A.L. rails on your Traeger Flatrock 3-Zone grill. Includes part numbers, required tools, and estimated completion time.
Applies to: Flatrock 3-Zone
Part # Grill SKU TF3CN59AU Grill SKU TF3CN59AN Contents Shelves Left FTK0010
(Buy on Traeger.com)FTK0010
(Buy on Traeger.com)FTK0088; OOS
Shelf only Right FTK0029
(Buy on Traeger.com)FTK0029
(Buy on Traeger.com)FTK0093; OOS
Shelf only P.A.L Rails Front Left FTK0020 FTK0020
FTK0090; OOS
Rail, Hardware Front Right FTK0011 FTK0011
FTK0089; OOS
Rail, Hardware Left Side FTK0024 FTK0024
FTK0092; OOS
Rail, Hardware Right Side FTK0022 FTK0022
FTK0091; OOS
Rail, Hardware
Side Shelves Replacement Steps
Tools Needed
- Phillips Screwdriver
- 1/2" - 3/8" Wrench (if replacing P.A.L Rail too)
Estimated Time to Complete
- 10 minutes
Before Performing Any Replacement Steps:
- Move all control knobs to the OFF position
- Unplug the grill from power, close the propane tank and disconnect the regulator hose
- Fold down the shelf.
- Remove the 4 screws attaching the shelf to the bracket, 2 on front and 2 on back.
- With those 4 screws removed the shelf should be able to be separated from the grill, leaving the bracket attached.
-
Replace the brackets: (skip if only replacing the shelf).
- With the brackets installed, install the shelf following the steps outlined in the assembly guide.
- Partially screw in 8 screws (G) into each of the two side shelves. Do not tighten all the way.
- Insert the two side shelves into the brackets, adding an additional screw once in place.
- Install the four P.A.L Rails in the following order: Front-left > Side-left > Side-right > Front-right.
Side Shelf P.A.L Rails Replacement Steps
Tools Needed
- 1/2" - 3/8" Wrench
Estimated Time to Complete
- 10 minutes
Replacement Steps
Pro Tip: Depending on the placement of the P.A.L rail being replaced, users may need to remove the adjacent rail as well.
Before Performing Any Replacement Steps:
- Turn burner knobs to OFF position, close the propane tank, and disconnect the regulator
- Unplug the grill from power
- Move all control knobs are in the OFF position. Unplug the grill from power, close the propane tank valve, and disconnect the regulator from the propane tank.
- Loosen the bolts holding the applicable P.A.L rail in place. Once loosened, the P.A.L rail should be able to be lifted off the bolts and away from the shelf.
- If necessary, replace any damaged bolts.
- Place the new PAL rail onto the loosened bolts.
- Tighten bolts, making sure the P.A.L rail remains level.
Still need help?
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.