Step-by-step instructions on how to replace the side shelf, side shelf brackets, and the side shelf P.A.L. rails on your Traeger Flatrock 3-Zone grill. Includes part numbers, required tools, and estimated completion time.
Applies to: Flatrock 3-Zone
Part # Grill SKU TF3CN59AU Grill SKU TF3CN59AN Contents Bracket Front-Right; Back-Left FTK0030 FTK0076 x1 bracket, Hardware Front-Left; Back-Right FTK0042 FTK0078 x1 bracket, Hardware Shelves Left FTK0010 FTK0010
FTK0088; OOS
Shelf only Right FTK0029 FTK0029
FTK0093; OOS
Shelf only P.A.L Rails Front Left FTK0020 FTK0020
FTK0090; OOS
Rail, Hardware Front Right FTK0011 FTK0011
FTK0089; OOS
Rail, Hardware Left Side FTK0024 FTK0024
FTK0092; OOS
Rail, Hardware Right Side FTK0022 FTK0022
FTK0091; OOS
Rail, Hardware
Side Shelves & Brackets Replacement Steps
Tools Needed
- Phillips Screwdriver
- 1/2" - 3/8" Wrench (if replacing P.A.L Rail too)
Estimated Time to Complete
- 10 minutes
Before Performing Any Replacement Steps:
- Move all control knobs to the OFF position.
- Unplug the grill from power, close the propane tank and disconnect the regulator hose
- Fold down the shelf.
- Remove the 4 screws attaching the shelf to the bracket, 2 on front and 2 on back.
- With those 4 screws removed the shelf should be able to be separated from the grill, leaving the bracket attached.
- Replace the brackets: (skip if only replacing the shelf).
- Remove the 2 screws from the front bracket, and the 2 from the back bracket.
- Install the new brackets.
- With the brackets installed, install the shelf following the steps outlined in the assembly guide.
- Partially screw in 8 screws (G) into each of the two side shelves. Do not tighten all the way.
- Insert the two side shelves into the brackets, adding an additional screw once in place.
- Install the four P.A.L Rails in the following order: Front-left > Side-left > Side-right > Front-right.
Side Shelf P.A.L Rails Replacement Steps
Tools Needed
- 1/2" - 3/8" Wrench
Estimated Time to Complete
- 10 minutes
REPLACEMENT STEPS
Pro Tip: Depending on the placement of the P.A.L rail being replaced, users may need to remove the adjacent rail as well.
Before Performing Any Replacement Steps:
- Turn burner knobs to OFF position, close the propane tank, and disconnect the regulator
- Unplug the grill from power
- Move all control knobs are in the OFF position. Unplug the grill from power, close the propane tank valve, and disconnect the regulator from the propane tank.
- Loosen the bolts holding the applicable P.A.L rail in place. Once loosened, the P.A.L rail should be able to be lifted off the bolts and away from the shelf.
- If necessary, replace any damaged bolts.
- Place the new PAL rail onto the loosened bolts.
- Tighten bolts, making sure the P.A.L rail remains level.