Step-by-step instructions for how to replace an induction fan on your Traeger pellet grill without WiFIRE. Includes part numbers, required tools, and estimated completion time.
Applies to:
Part #: Description: KIT0019 Draft Induction Fan (Buy on Traeger.com) KIT0182 Draft Induction Fan
Tools Needed
- 1/4" Wrench or Nut Driver
Estimated Time to Complete
- 5 minutes
How to Replace a Draft Induction Fan on an AC Grill
- Turn off and unplug your grill.
- If your hopper has a bottom service panel, remove it by unscrewing the screws securing it in place.
- Locate your draft induction fan. If having difficulty, find the orange wires and follow them to the fan.
- Unplug the white Molex connector at the end of the fan's orange wire harness that connects the fan to the controller's orange and white wire harness.
- Remove the four screws holding the fan in place and pull the fan/fan motor out of the grill.
- Position the new fan in place and use the four screws you just removed to tighten it in.
- Connect the fan's Molex connector to the controller.
- Replace the hopper service panel, if applicable.
Additional Resources
- What Is an induction fan?
- Diagnosing Induction Fan Issues on a Non-Connected Grill
- Induction fan replacement instructions for D2 WiFIRE grills
- Induction fan replacement instructions for new Timberlines & Ironwoods
Still need help?
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.