How to Replace an Ignitor on a Flatrock 3-Zone Griddle

Applies to: Flatrock 3-Zone 

Part #:	Description:
FTK0009	Ignitor

Tools Needed

• Phillips Screwdriver

Estimated Time to Complete

• 10-15 minutes

Replacement Steps

1. Find the ignitor needing replacing.

   Pro Tip: The flame sensor and the ignitor look very similar. The flame sensor is mounted on the bottom of the grill; the ignitor comes from the front where the knob is.
2. Remove the screw holding the ignitor to the ignitor bracket.
3. From underneath grill, find the control housing panel and remove the two thumb screws holding it in place. Slide access panel toward the front of the grill to remove panel.
   
4. If working with another person, have the second person pull on the ignitor so you (while still under the grill) can identify which black braided ignitor wire harness to disconnect.
5. Disconnect the ignitor wire harness by pulling it away from the wire harness box.
   
6. Pull the ignitor away from the front of the grill, bringing its disconnected wire with it.
   You may have to pull out and slightly to the left.
7. Have person 2 feed the new ignitor wire through its entry point in the grill's belly. When you see the wire, pull it through the bottom and connect it to the wire harness box.
8. Secure the ignitor to the ignitor bracket with the provided screw.
   1. The ignitors need to be pointing toward the burners, and the tip should be between 4.5 (approx. 3 stacked US pennies) and 5.5 mm (approx. 4 stacked US dimes). Placement is very important as it may cause the ignitor to be weak or function inconsistently (see step 12).
   2. If an ignitor is too far, it won't spark or only one of the three ignitors will spark with every click since they would require more charge.
   3. If an ignitor is too close, the spark will be weaker since it requires less charge to bridge the gap between ignitor and burner. 
      
9. Make sure the ignitor wire harness is pulled entirely through the grill so it rests in the control housing before reattaching the control housing panel with the 2 thumb screws you removed in step 5.
10. Once ignitor is replaced and with the cooktop removed, have the customer plug in the grill and press the Ignite button.
    1. Check to see if the spark from each ignitor is strong and consistent.
    2. If the spark is weak or inconsistent, there is likely an issue with the ignitor's distance from the burner. 
11. Replace the cooktop.