Step-by-step instructions on how to replace the grease keg, chute and keg trim piece on your Traeger Flatrock 3-Zone grill. Includes part numbers, required tools, and estimated time of completion.
Applies to: Flatrock 3-Zone
Part #: Description: FTK0028 Grease Chute FTK0001 Grease Keg FTK0071 Grease Keg Front Trim Piece
Tools Needed
- N/A
Estimated Time to Complete
- Less than 2 minutes
Grease Keg Replacement Steps
Before Performing Any Replacement Steps:
- Unplug the grill from power
- Close the propane tank, and disconnect the regulator
- Slide out the EZ-Clean Grease Keg with keg liner
- Empty and discard the keg liner. Line the EZ-Clean Grease Keg with a new liner and slide it back into the bracket on the bottom of the Flat Top Grill (you will feel it “drop” into place when installed fully).
Grease Chute Replacement Steps
Before Performing Any Replacement Steps:
- Unplug the grill from power
- Close the propane tank, and disconnect the regulator
- Open the cooktop lid, remove the cooktop
- Grip the grease chute and pull it straight up. It should slide out.
- Get new grease chute, and line up the tabs as you drop it into place.
- Replace the cooktop.
- Close the cooktop lid.
Grease Keg Front Trim Piece Replacement Steps
- Remove the old grease keg front trim piece by pulling it away from the grill
- Snap the replacement piece in place.
Still need help?
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.