1. Traeger Support
  2. Replace a Part
  3. Flat Top Grill Parts
  4. IronTop

How to Replace a Burner on an IronTop Griddle

  • Updated

What's in This Article?

Step-by-step instructions for how to replace the burner on your Traeger IronTop 2-Burner and IronTop 4-Burner flat top grill. Includes part numbers, required tools, and estimated completion time. 

Applies to:

Part #: Model:
FTK0135 H-Burner - IronTop 2-Burner
FTK0160 Stick Burner - IronTop 4-Burner 

Pro Tip: The IronTop 2-Burner grill has 2 H-burners, while the IronTop 4-Burner has 4 stick burners.

2 Burner burner tubes.jpg
H-Burner
4 burner burner tubes.jpg
Stick Burner

Tools Needed

  • Phillips Screwdriver

Estimated Time to Complete

  • 5 minutes
IronTop 2-Burner Replacement Steps

Remove Old Burner

Before Performing Any Replacement Steps:

  • Turn burner knobs to OFF position, close the propane tank
  • Ensure the grill is completely cooled
  • Open the lid and remove the cooktop
  1. Unscrew the x2 screws holding the burner in place (screws located at the top of the burner, one on each side).
    Image of where the screws are located to remove the burner.
  2. Lift the burner up and pull it out of the burner hole.
    Image of H-burner being removed from griddle.
  3. Unhook the ignitor wire from the ignitor by pulling it away from the ignitor.
    Image showing red circle outlining the location of the ignitor.
  4. Pull burner out of the grill.

Replace New Burner

  1. Reattach the ignitor wire to the ignitor on the new burner.
  2. Slide burner into the burner slot.
    Image showing location of the burner reinstalled into the burner slot.
  3. Replace x2 screws to secure the new burner.
    Image showing location to replace screws.
  4. Replace the cooktop and close the lid.

 

IronTop 4-Burner Replacement Steps 

Remove Old Burner

Before Performing Any Replacement Steps:

  • Turn burner knobs to OFF position, close the propane tank
  • Ensure the grill is completely cooled
  • Open the lid and remove the cooktop

  1. Remove the hairpin from the burner.
    Image showing location of the haripin on the burner.

    Image showing hairpin being removed from the burner.

  2. Lift the burner off of the notch.
    Image of stick burner being removed from the griddle.
  3. Disconnect the ignitor wire from the ignitor by pulling it off.
    Image showing location of the ignitor on the stick burner.
  4. Pull old burner out of the burner slot.

Replace New Burner

  1. Slide the ignitor wire onto the new ignitor.
  2. Slide the burner into the burner slot.
  3. Place the new burner on the burner notch and replace x1 hairpin.
    Image showing the stick burner reinstalled with the hairpin in place.
  4. Replace the cooktop and close the lid.
Still need help?
If you need help replacing your part, or if you run into additional concerns after replacement, contact Traeger Support. We're ready to help 365 days a year.
Previous
Next
46464067745051

Was this article helpful?

0 out of 0 found this helpful