REPLACE A TIMBERLINE LID SENSOR & LIGHT

What's in This Article?

How to install a lid sensor/light on a Timberline grill. 

PART NUMBER: KIT0633

REPLACEMENT STEPS

  1. Remove hopper side access panel.
  2. Remove smart combustion cover.
  3. Locate lid and light sensor cables and disconnect from kirby
  4. Cut zip tie holding light / lid sensor cables
  5. Open hopper lid
  6. Remove screw holding ETL grate and remove ETL grate
  7. Remove remaining screws on the display access panel
  8. Remove display access panel with light / lid sensor attached
  9. Remove screws holding light / lid sensor to access panel
  10. Attach new lid / light sensor to access panel and repeat previous steps in the reverese order, adding a new zip tie in place of the one that was cut.
Previous
Next
6433809355163

Was this article helpful?

2 out of 4 found this helpful