TIMBERLINE: IGNITOR ERROR DETECTED

What's in This Article?

Information on the "Ignitor Error Detected" message which can appear on Timberline grills and how to resolve it.

  • This error number used to display as “0025” in firmware version 01.00.05. The error number changed to “0026” in firmware version 01.00.06. 

gen2-0026_ignitor_error_detected.jpeg

 

CAUSE

The ignitor’s voltage does not match the voltage of the power system (i.e., a 120VAC ignitor is used on a 220VAC power system or vice versa)

This safety check only runs during grill seasoning. The most common cause of this error is the grill shipping with the wrong ignitor. Using a non-Traeger ignitor could also potentially cause this error.

 

WHAT DOES THE GRILL DO WHEN THIS ERROR OCCURS?

This is a critical error. The grill will shut down.

 

WHAT TO DO

  1. Make sure FIRMWARE is up to date.
    1. If the error number displayed is the old number, update the firmware. 

    2. On your controller display, find the ABOUT GRILL menu option or check this on the Traeger App.

  2. Season the grill again:
    1. Power cycle the grill.
      1. Turn off the grill using the power button on the front of the grill and unplug the grill.
      2. Ensure the grill is off for 30 seconds.
      3. Plug in the grill and turn it on.
    2. Once the grill has powered up, season the grill
      • This will run the safety check to validate the ignitor, clear the error, and then perform the check. If the ignitor is not recognized, the grill will shut down.
  3. If the error continues, contact Customer Support.
Previous
Next
6340758260763

Was this article helpful?

2 out of 3 found this helpful