Grease Keg & Chute Replacement - Flat Top Grill

What's in This Article?

Steps to replace grease management parts on a Traeger flat top grill, including the grease keg and the grease chute.

 

Applicable SKUs

Grease Bucket Grease Chute

FTK0001

FTK0028

 

Replacing a Flat Top Grill Grease Keg

FTK0001_GreaseBucket_Flatrock-3482_1.jpg

  1. Unplug the grill from power, close the propane tank and disconnect the regulator.
  2. Slide out the EZ-Clean Grease Keg with keg liner.
    greasekeg1.png
  3. Empty and discard the keg liner. Line the EZ-Clean Grease Keg with a new liner and slide it back into the bracket on the bottom of the Flat Top Grill (you will feel it “drop” into place when installed fully).
    grease_keg2.png

Replacing a Flat Top Grill Grease Chute

FTK0028_GreaseShoot_Flatrock-3557_1.jpg

  1. Unplug the grill from power, close the propane tank and disconnect the regulator.
  2. Open the cooktop lid.
  3. Remove the cooktop.
  4. Grip the grease chute and pull it straight up. It should slide out.
    grease_chute_1.png
  5. Get new grease chute, and line up the tabs as you drop it into place.
    grease_chute_2.png
  6. Replace the cooktop.
Previous
Next
12756592329499

Was this article helpful?

3 out of 10 found this helpful