Steps to replace a side shelf, side shelf brackets and the side shelf P.A.L rails on a flat top grill.
Applicable SKUs
Bracket | Shelves | P.A.L Rails |
FTK0030 | FTK0010 FTK0029 |
FTK0011 FTK0020 FTK0022 FTK0024 |
Replacing Side Shelves & Brackets on Traeger Flat Top Grills
TOOLS NEEDED:
Phillip's-head Screwdriver
1/2" - 3/8" Wrench (if replacing P.A.L Rail too)
REPLACEMENT STEPS
- Move all control knobs are in the OFF position. Unplug the grill from power, close the propane tank valve, and disconnect the regulator from the propane tank.
- Fold down the shelf.
- Remove the 4 screws attaching the shelf to the bracket, 2 on front and 2 on back
- With those 4 screws removed the shelf should be able to be separated from the grill, leaving the bracket attached.
- Replace the brackets (skip if only replacing the shelf).
- Remove the 2 screws from the front bracket, and the 2 from the back bracket.
- Install the new brackets.
- With the brackets installed, install the shelf following the steps outlined in the assembly guide.
- Partially screw in 8 screws (G) into each of the two side shelves. Do not tighten all the way.
- Insert the two side shelves into the brackets, adding an additional screw once in place.
- Install the four P.A.L Rails in the following order: Front-left > Side-left > Side-right > Front-right.
Replacing Side Shelf P.A.L Rails on Traeger Flat Top Grills
TOOLS NEEDED:
1/2" - 3/8" Wrench
REPLACEMENT STEPS
Depending on the placement of the P.A.L rail being replaced, users may need to remove the adjacent rail as well.
- Move all control knobs are in the OFF position. Unplug the grill from power, close the propane tank valve, and disconnect the regulator from the propane tank.
- Loosen the bolts holding the applicable P.A.L rail in place. Once loosened, the P.A.L rail should be able to be lifted off the bolts and away from the shelf.
- If necessary, replace any damaged bolts.
- Place the new PAL rail onto the loosened bolts.
- Tighten bolts, making sure the P.A.L rail remains level.